Check the COM port on the computer to make sure it is linked with the data switch successfully.

where.

0. This document describes FortiOS 7.

0 Administration Guide, which contains information such as Connecting to the CLI.

Set the IP address and netmask of the LAN interface config system interface edit <port> set ip <ipaddress> <netmask> set allowaccess (http https ping ssh telnet) end.

This document describes FortiOS 7. Start HyperTerminal, enter a name for the connection, and select OK. 0 CLI commands used to configure and manage a FortiGate unit from the command line interface (CLI).

To connect to the CLI Connect the FortiManager console port to the available communications port on your computer.

Install and run SecureCRT software on the computer. Using FortiGate GUI to Configure FortiLink (Single Link) The following sections describe how to configure FortiLink using a single switch port. The cable used is the same as used with Cisco devices, nothing special.

. set name fortiswitch-dispatch.

Get the baudrate execute console baudrate.

To connect to the CLI Connect the FortiManager console port to the available communications port on your computer.

Example. You can try with factory reset and test again or t here is a MGMT port on the FSW.

. 4.

Connect your computer to your Fortinet device's serial port to establish a serial link.
To connect to the CLI Connect the FortiManager console port to the available communications port on your computer.
Configure the FortiLink port on the FortiGate using the following steps 1.

.

.

. Network Securit. .

0 Administration Guide, which contains information such as Connecting to the CLI. 0 that are supported on each series of FortiSwitch models. 0. Enable or disable PoE pre-standard detection. 1. When per-device management is enabled, you can use the FortiSwitch Manager pane to configure ports for each managed switch.

To view the baud rate used for the RS-232 serial console port, enter the show console command.

FortiSwitch port features. Set up and connect to the serial.

If both priority power allocation and FCFS power allocation are selected, the physical port setting takes precedence over the global setting.

1.

4.

The following figure shows the.

Start HyperTerminal, enter a name for the connection, and select OK.